Home Contact Info Site Map 

Core PinsSleevesCustomPicturesBack

         

 

With experience learned over the years of manufacturing, we provide a quality product. Custom ground from high quality tool steels. 

Sleeves  Used in areas where a longer travel ID bearing is required. To push a molded part off a core pin or allow a longer pin to retract and remain inside a the bearing surface. Longer than standard ID bearing surface. Thin wall down to .0075 (S-7) for medical molds. A-2 A-10 D-2 H-13 M-2 S-7 440-C 420 tools steels  

 
Back

Bushing Headed and headless. Runner and puller bushings with precision ground heads and snap ring retainer groove . Cavity blanks with a precision hole centered and honed to +-.0001 tolerance.  420  440-C  A-2  S-7  A-10  H-13  O-1

Specialty bushings   Cold heading stripper and knockout sleeve. High precision carbide guides sleeves, coining sleeves, wire feeder tubes.  KO sleeves and stripper sleeves. Trim die support sleeves.  O-1  A-2  S-7  M-2  D-2  

Core Pins  Most materials used in mold making. M-2 A-2 S-7 420 440-C H-13. Heat treat trough hard. Precision ground from bar stock. 

Ejector blades for ejecting thin section where a round ejector will not work. Custom grind pins to fit your tool. 

other services 

Drilling

Grinding
 
Honing

 

home
contact
Site Map
Back

Send mail to JeffM with questions or comments about this web site.
Copyright © 2002 Matthews Gauge, Inc. Low Budget Web Design by Jeff © 
All content and pictures are the sole property of Matthews Gauge, Inc.  All tooling components viewed in pictures were made at Matthews Gauge. The molded samples are those sent us from our customers. Do not use our pictures without our written permission from Matthews Gauge.     location yahoo maps