Hone 714-540-2846

HONING

Hones: Horizontal
3 - SUNNEN 1804 auto stroke and auto sizing hones
2 - SUNNEN 1600 manual hones: sleeves held to .0002 tolerance to slip fit core pins; .0620 through .7500

We do our own in-house honing to control size and consistency of hole size and surface condition. Dial bore gages are used to check ID's for "bell mouth" condition and also for "out of round". We make our own extra long pin gages to simulate core pin resistance to bearing surface and for slip fit throughout the ejection cycle. Sleeves and bushings are honed with extra fine stones to produce a smoother bearing surface. The smoother the bearing surface is, the longer the service life of the core pin or ejector pin will have.

home
contact
Site Map
Back

All content and pictures are the sole property of Matthews Gauge, Inc. All tooling components viewed in pictures were made at Matthews Gauge. The molded samples are those sent us from our customers. Do not use our pictures without our written permission from Matthews Gauge. location yahoo maps

Send mail to JeffM with questions or comments about this web site. Copyright © 2002 Matthews Gauge, Inc. Low Budget Web Design by Jeff ©

All content and pictures are the sole property of Matthews Gauge, Inc. All tooling components viewed in pictures were made at Matthews Gauge. The molded samples are those sent us from our customers. Do not use our pictures without our written permission from Matthews Gauge. location yahoo maps

Send mail to JeffM with questions or comments about this web site.
Copyright © 2002 Matthews Gauge, Inc. Low Budget Web Design by Jeff ©